Heatefficiency of frame houses: what should be known?

It is perfectly known that any hot body which got on cold Wednesday will begin to give the heat. So the system seeks to achieve thermal balance. The principle well-known and working everywhere without exception. Also houses which give heat which is saved up inside to the winter period did not become an exception. It leaves through doors, windows, walls, a roof. If not to heat the building, then at some point temperature in rooms completely will be equal to ambient temperature. Speed of this process directly depends on such characteristic as heatefficiency.

There was an opinion that the heatefficiency of stone houses is higher, than at frame. Explain it with the fact that the stone accumulates heat in the course of heating of rooms and then returns back this heat. However, this judgment is very far from reality.

It is worth recognizing that the stone has very quite good thermal capacity in comparison with walls of the frame house. However the heatefficiency of frame houses is much higher, than at stone. It is rather simple to explain it: the most part of heat which is saved up by a stone dissipates outside. Besides, to accumulate heat in a stone, it is necessary to spend a large amount of energy for heating. Thus, it is possible to note the low efficiency of stone walls.

It turns out that the good thermal capacity of the house from a stone becomes useful when it is under frequent influence of sources of heat (for example, sunshine). If there is no source of heat, then the house from a stone will get temperature close to the environment, less than in 10 hours. That is, during the winter period the house can be chilled in only several hours without heating.

The result of the made experiment can strike many. It turned out that warm frame houses spend twice less heat, than constructed of a stone or a brick. In many respects the fact that demand for frame houses continues to increase every year is explained by it.

Than to warm the frame house?

Well proved heater is mineral wool. It has a number of worthy advantages:
* Good resistance to burning;
* Provides an additional noise isolation;
* It is rather easy to mount.

However, you should not forget that the additional waterproofing and protection against wind from outer side of the house will be required.

Also it is worth paying attention to heating system elements. Experts recommend to use pipes from the sewed polyethylene or metalplastic. Their main advantage consists in ability not to peremerzat even at sharp negative temperatures. Besides, they rather just are established in walls.

From where does heat leave?

Turnkey frame houses when commissioning check by means of thermal imagers. If the technology of construction was observed, then doors and windows will be the main places of heatlosses. At the same time, even thick double-glazed windows from the best global manufacturers pass heat, than walls much stronger. Certainly, if at construction mistakes were not made.

If over time you noticed that the frame house became more cold and longer gets warm, then survey it by means of the thermal imager regarding identification of sources of losses of heat.
Also it is worth surveying attentively joints between a floor and walls and also the place of a prileganiye of a rafter system. Exactly here unfair workers usually are mistaken at assembly. Same, in turn, a serious occasion to address for construction in the professional company.

Source of www.karkasniki.ru/